1.0 Specifications
•
Dimensions (HxWxD):
5 in. x 2.8 in. x 2.2 in.
(12.7 cm x 7.1 cm x 5.6 cm)
•
Input Power:
9 to 15 VDC, 22 mA DC nominal (up to
52 mA DC during walk testing, stored
alarms, or trouble conditions). Use only
an Approved Limited Power Source.
•
Standby Power:
No internal standby battery. Standby
power
must
be provided by an Approved
Limited Power Source. Twenty-two
mAh required for each hour of standby
time needed.
Four hours (88 mAh)
minimum are required for UL Listed
Requirements.
•
Alarm Relay:
Silent operating Normally Closed reed
relay. Contacts rated 3 watts, 125 mA,
28 VDC maximum for DC resistive
loads; and protected by a 4.7 ohm, 0.5
watt resistor in the common "C" leg of
the relay. To be connected to a SELV
(Safety Extra-Low Voltage) circuit only.
Do
not
use with capacitive or inductive
loads.
•
Tamper:
Normally Closed (with cover on).
Contacts rated at 28 VDC, 125 mA max.
To be connected to a SELV (Safety Extra-
Low Voltage) circuit only. Connect
tamper circuit to 24-hour protection
circuit.
•
Trouble
:
Solid State output shorts to ground (-)
when the detector is in a supervision
trouble condition. Maximum load is 25
mA, Vsat @ 10 mA = 0.5 VDC.
•
Temperature Range:
-40°F to +120°F (-40°C to +49°C).
For UL Listed requirements, the
temperature range is +32°F to +120°F
(0°C to +49°C), indoor use.
•
Microwave Frequency:
DS970:
10.525 GHz (UL Listed)
DS970A:
10.687 GHz (Export only,
not
UL Listed)
DS970B:
9.9 GHz (Export only,
not
UL Listed))
•
Coverage:
Broad (standard):
70 ft. by 70 ft. (21 m by 21 m)
Long Range (optional):
100 ft. by 10 ft. (30 m by 3 m)
•
Internal Pointability:
+2° to –10° Vertical, ±10° Horizontal.
•
Options:
B328 Gimbal Mount Bracket, B335
Low Profile Swivel Mount Bracket,
B338 Ceiling Mount Bracket, OLR92
Long Range Barrier Lens, TC6000
Test Cord
NOTE:
Use of a bracket may reduce range and increase dead zone
areas.
•
Reading Bosch Security Systems, Inc. Product Date Codes
For Product Date Code information, refer to the Bosch Security
Systems, Inc. Web site at:
http://www
.boschsecurity
.com/
datecodes/
•
Compliance:
This device complies with Part 15 of the FCC Rules
and with RSS-210 of Industry and Science Canada. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesirable operation.
Changes or modifications not expressly approved by Bosch
Security Systems can void the user’s authority to operate the
equipment
Product Code: D8570
